Kittenbot HK Sharing Hub English

Welcome to KittenBot HK English Sharing Hub
Extension Boards
AI Modules
Wifibrick & IoT Solutions
Functional Modules
Motors and Servos
Microsoft Jacdac Series
- What's Jacdac?
- Jacdac Hardware
  Jacdac+MakeCode Quickstart
  Jacdac+MicroCode QuickStart
  Jacdac Kit A
  Jacdapter
  Jacdac Slider
  Jacdac Rotary Button
  Jacdac RGB Ring
  Jacdac Button
  Jacdac Magnet Sensor
  Jacdac Light Sensor
  Jacdac Hub
  Jacdac Kit B
  Jacdac Power Module
  Jacdac Haptic
  Jacdac Accelerometer
  Jacdac Relay
  Jacdac Environment
  Jacdac RGB Light Strip
  Jacdac Servo Driver
  Jacdac Ultrasound
  Jacdac Duckybot
  Duckybot Instructions
  Wake Up Duckling
  Environment Sensing
  Fall Detection
  Following Duckling
Main Controllers
Educational Kit Sets
Programming Platforms
Scientific Measuring Device Kit
Kittenbot & Bricklink Studio
Kittenbot HK SharingHub Chinese

Powered by GitBook

On this page

Installing the Robotbit Base:
Robotbit Base Orientation

Robotbit Base Shield

PreviousRobotbit Edu Introduction NextRobotbit Edu Coding with MakeCode

Last updated 1 year ago

Each Robotbit comes with a base, not only does using this base protect the bottom of the Robotbit from short circuiting, it also provides mounting holes for Lego Technic pins or screws, allowing more choices for building your robots.

Installing the Robotbit Base:

Robotbit Base Orientation

Pay attention to the orientation of the base!!

The indents must align with the charging ports and the power switch of the Robotbit!!